MIXER DIGITAL YAMAHA TF5

Mã sản phẩm: TF5

Giá: Vui lòng liên hệ

Nhà sản xuất: YAMAHA

Tình trạng: Còn hàng

Số lượng:

HÀNG CHÍNH HÃNG

BỎ VÀO GIỎ HÀNG

Mô tả
Thông số kỹ thuật
Nhận xét

High input capacity and fader count makes this powerful console ideal for larger applications.

33 motor faders (32 channels + 1 master)
48 input mixing channels (40 mono + 2 stereo + 2 return)
20 Aux (8 mono + 6 stereo) + Stereo + Sub buses
8 DCA groups with Roll-out
32 analog XLR/TRS combo mic/line inputs + 2 analog RCA pin stereo line inputs
16 analog XLR outputs
34 x 34 digital record/playback channels via USB 2.0 + 2 x 2 via a USB storage device
8 Effects and 10 GEQ
1 expansion slot for NY64-D audio interface card

Thông số kỹ thuật

Outline

Fader Configuration		32 + 1 (Master)
Mixing Capacity	Input Channels	48 (40 mono + 2 stereo + 2 return)
	Aux Buses	20 (8 mono + 6 stereo)
	Stereo Buses	1
	Sub Buses	1
Input channel functions		8 DCA Groups
I/O	Inputs	32 mic/line (XLR/TRS combo) + 2 stereo line (RCA pin)
I/O	Outputs	16 (XLR)

Ngoại tuyến

I/O	Khe mở rộng	1

Outline

On-board processors	DSP	8 Effects + 10 GEQ
USB		34x34 USB Audio Interface, 2-track recording via USB Storage Device

Thông số kỹ thuật chung

Tỷ lệ tần suất lấy mẫu	Bên trong	48 kHz
Độ trễ tín hiệu		Less than 2.6 ms, INPUT to OMNI OUT, Fs=48 kHz

General specifications

Fader		100 mm motorized, Resolution = 10-bit, +10 dB to –138 dB, –∞ dB all faders

Thông số kỹ thuật chung

Tổng độ méo sóng hài		Less than 0.05% 20 Hz–20 kHz @+4 dBu into 600 , INPUT to OMNI OUT, Input Gain=Min. (Measured with a –18 dB/octave filter@80 kHz)
Đáp tuyến tần số		+0.5, –1.5 dB 20 Hz–20 kHz, refer to +4 dBu output @1kHz, INPUT to OMNI OUT
Dãy động		110 dB typ., DA Converter, 107 dB typ., INPUT to OMNI OUT, Input Gain=Min.
Mức nhiễu & Ồn	Nhiễu đầu vào tương đương	–128 dBu typ., Input Gain=Max. (Measured with an A-Weight filter)
Mức nhiễu & Ồn	Nhiễu đầu ra thặng dư	–85 dBu, ST master off (Measured with an A-Weight filter)
Xuyên âm		–100 dB (Measured with a –30 dB/octave filter@22 kHz), adjacent INPUT/OMNI OUT channels, Input Gain=Min.
Yêu cầu về nguồn điện		100–240 V 50/60 Hz
Tiêu thụ Điện		120 W
Kích thước	Rộng	866 mm (34.1in)
	H	225 mm (8.9in)
	Sâu	599 mm (23.6in)
Trọng lượng tịnh		20.0 kg (44.1lb)
Phụ kiện		Quick Guide, Power Cord, CUBASE AI download information

General specifications

Options		Expansion Card, Foot Switch (FC5)

Thông số kỹ thuật chung

Khác		Operating temperature range: 0–40 °C, Storage temperature range: -20–60 °C

Recording/ Playback

PC/Mac (USB2.0)	Recording 34 tracks, Playback 34 tracks
USB Storage Device	Recording 2 tracks (USB hard drive/ SSD)*, Playback 2 tracks (USB hard drive/ SSD/ thumb drive)

*Please note - USB thumb drives are not supported by TF for recording purposes. Please refer to this link for compatible hard drives.

Analog input characteristics

Input Terminals	GAIN	Load Impedance	For Use With Nominal	Input Level			Connector	balanced / Unbalanced
Input Terminals	GAIN	Load Impedance	For Use With Nominal	Sensitivity*1	Nominal	Max. before clip	Connector	balanced / Unbalanced
INPUT1-32	+66dB	7.5KΩ	50-600Ω Mics or 600Ω Lines	-82dBu (61.6V)	-62dBu (0.616mV)	-42dBu (6.16mV)	Combo Jack (XLR-3-31 type 2 or TRS phone 3)	Balanced
INPUT1-32	-6dB	7.5KΩ	50-600Ω Mics or 600Ω Lines	-10dBu (245mV)	+10dBu (2.45V)	+30dBu (24.5V)	Combo Jack (XLR-3-31 type 2 or TRS phone 3)	Balanced
ST IN 1,2	—	10kΩ	600Ω Lines	-30dBV (31.6V)	-10dBV (316mV)	+10dBV (3.16V)	RCA Pin Jack	Unbalanced

*1. Sensitivity is the lowest level that will produce an output of +4dBu (1.23V) or the nominal output level when the unit is set to maximum gain. (All faders and level controls are at maximum position.)
*2. 1: GND, 2: HOT, 3: COLD
*3. Tip: HOT, Ring: COLD, Sleeve: GND
*In these specifications, 0dBu = 0.775Vrms.
*+48V DC (phantom power) can be supplied to INPUT XLR type connectors via each individual software controlled switch.

Analog output characteristics

Output Terminals	Source Impedance	For Use With Nominal	GAIN SW	Output Level		Connector	balanced / Unbalanced
Output Terminals	Source Impedance	For Use With Nominal	GAIN SW	Nominal	Max. before clip	Connector	balanced / Unbalanced
OMNI OUT 1-16	75Ω	600Ω Lines	“+24dBu” position (default)	+4dBu (1.23 V)	+24dBu (12.3 V)	XLR-3-32 type *1	Balanced
PHONES *3	100Ω	40Ω Phones	—	3mW	75mW	Stereo Phone Jack (TRS) *2	Unbalanced

*1.1: GND,2: HOT, 3: COLD
*2 Tip: LEFT, Ring: RIGHT, Sleeve: GND
*3 The position of the level control is lowered by 16dB from the maximum.
*In these specifications, 0dBu = 0.775Vrms.
*All output DA converters are 24bit, 128times oversampling.